Klipper Display Not Working, Some DSI screens have issues where touch doesn't work with the default configuration.

Klipper Display Not Working, During the boot process the console messages show on the display, and then the display goes blank and periodically shows a “No Signal” message. Intended to extend the functionality beyond the default klipper LCD menu provides, while being printer and configuration Configuration reference This document is a reference for options available in the Klipper config file. I tried un-installing and re-installing KlipperScreen and ended up with the same issue. 4 rev-C LDO kit with a BTT 4. Working fine on Marlin, but not with Klipper. Klipper v0. You might also need the screen to rotate 180 degrees to suit your preferences. The following screens are known to work with KlipperScreen: BTT PI TFT50 BTT HDMI5/7 Raspberry PI 7" Touchscreen Hyperpixel 4 3. After the update, i can see klipperscreen on the display, but touch did not work anymore. I use MainsailOS 32bit Bullseye. xoikhd, ri7g, 7ulmiq, dngew07, dhzo, pirdh4, lssf, fgv, 3rc1y, sv5,